Hitachi GR2000 Series Configuration Commands page 87

Description:
Default:
Description:
Default:
Description:
Default:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
Description:
Default:
Flow detecting condition parameter
Description:
GR2K-GA-0014
Ver. 07-02
The subject interface name set in the IP information or the
IP-address information is designated. (The IP information or
IP-address information should have been set before inputting
this command.) The RM Ethernet is not supported. For details,
refer to Table 1-5.
No default is possible.
Inbound/Outbound is designated. Either one or both of the
Inbound/Outbound can be set simultaneously.
in :Inbound (designation on the frame input side)
out:Outbound (designation on the frame output side)
No default is possible.
The flow control is nullified by each input/output interface.
No default is possible.
The list numbers are designated.
Default is possible only for the case of indication. All the lists
are indicated at default.
IPv6 filter list: 40001 to 60000 (decimal)
Specifies the range of a list number. This parameter can be
specified only when a blank list number is displayed.
The range of the list number to be displayed corresponds to all
list numbers.
IPv4 filter list: 1 to 20000 (decimal)
IPv6 filter list: 40001 to 60000 (decimal)
Displays the blank list number.
Cannot be omitted when the blank list number is displayed.
Displays the top blank list number in the specified range.
Cannot be omitted when the top list number of a blank list
number is displayed.
The high-order protocol numbers or protocol names are
designated. If all protocols are taken as the object, IP is
designated.
Filtering/QoS Information
1-45