Table 1-34 List Of Interfaces That Support Flow Control - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
-drop: The agreed packet is discarded.
Default:
Range of value:
This parameter enables the function of policy routing. Packets are transmitted to
the output destination specified using this option when relaying the packets that
coincide with filter conditions. For the list information that sets policy routing,
specify in (Inbound) and then specify it as the flow control on the receive side.
<Interface Name>:
Specifies the interface name at the output destination (the interface name set
using ip information) (refer toTable 1-34).

Table 1-34 List of Interfaces that Support Flow Control

Interface Name
<Line Name>
RmEthernet
<DLCI Name>
<VC Name>
<Group Name>
<Timeslot Name>
<Peer Name>
<Tunnel Name>
<VLAN Name>
<Session Name>
: Setting possible.
-: Setting impossible
*1: VLAN line and PPOoE session are not supported.
Specifies the next hop IPv6 address.
Default:
Range of value:
Designate the connection branching index numbers (indexes designated by the
DLCI group information or the Vc-Group information). When relaying a packet
that agrees with the flow detecting condition, DLCI/VC designated in the group is
selected and transmitted. Designate "out" (Outbound) for the list information that
has set the connection branching index number, as the flow control of the
transmission side. It cannot be set in the tunnel interface.
Default:
Range of value:
1-50
-forward
None
Availability of Support
---
---
---(1*)
--- (1*)
-forward
<IP Address>: Set the IPv6 address described below.
IPv6 address
:(nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn):
0:0:0:0:0:0:0-ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
-forward
0 to 7.
GR2K-GA-0014
Ver. 07-02