Table 1-100 Parameters For Each Queuing Mode - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Sends packets from high priority queues. Packets are sent from lower priority
queues only if there are no packets in higher priority queues. Table 1-100,
Parameters of each queuing mode, gives a list of parameters for each queuing
mode.
If queue 4 is set as the minimum guaranteed bandwidth and it contains packets,
the packets are sent unconditionally. Send information is output from queues 1
- 3 according to weight. Table 1-100, Parameters of each queuing mode, gives a
list of parameters for each queuing mode.
Send information is output from queues 1 - 4 according to the weight. Table
1-100, Parameters of each queuing mode, gives a list of parameters for each
queuing mode.

Table 1-100 Parameters for each queuing mode

Item
Queue count
Physical line maximum send
bandwidth
Send bandwidth not subject to
shaping
User priority rewrite in
Tag-VLAN
Traffic type
Interface name
VLAN line maximum send
bandwidth
Output Queue mode
priority
control
Queue length
LLQ+3WFQ Queue mode
Minimum
guaranteed
bandwidth (low
latency queuing)
Maximum send
bandwidth
(weighted fair
queuing)
Queue length
1-214
Parameter
--
--
--
-set_default_user_priority
-set_default_user_priority
_off
rate_limited_ququeing
<VLAN Name>
peak_rate
priority
<Length>
llq+3wfq
10%, 20%, 30%, 40%,
50%, 60%, 70%, 80%,
90%, 100%
<Rate>
<Length>
Supported
specifications
1000BASE-SX
Description
1000BASE-LX
1000BASE-LH
NEB1G-2D
4 queue --
986Mbit/s --
6Mbit/s --
Sets rewrite of user priority in
Tag-VLAN.
Fixed bandwidth Set when securing fixed bandwidth.
Sets name of interface specifying
send control.
500kbit/ to Sets maximum send bandwidth of
980Mbit/s VLAN lines.
Output priority Sets outbound priority control.
control
0 to 4000(*1) Sets queue length for each queue.
LLQ+3WFQ Sets low latency queuing + weighted
fair queuing (LLQ+3WFQ).
Selects from 10%, 20%,
30%,40%,50%,60%,70%,80%,90%
and 100% and sets.
1 to 100% Sets maximum send bandwidth for
each queue.
0 to 4000(*1) Set length of each queue.
GR2K-GA-0014
Ver. 07-02