Filter-Group (Information On Filter Group Of Old Bsd Unix-Based Command System) - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
7. Display of blank entry number
Display of all blank entry numbers
Display of first blank entry number
Related Configuration Object
filter
filter-group
filter-interface
qos-tos-map
dlci_group
vc-group
policy-group
Precautions
1. A maximum of 1024 filter list conditions can be created with each device.
2. Filter list being used by filter group cannot be deleted.
3. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
1.1.12 filter-group (Information on Filter Group of Old BSD UNIX-Based Command
System)
Function
Object for creation, modification, deletion, and display of the filter group information.
Register in the order of judging the filter conditions defined by the filter list. A
maximum of 256 filter groups can be created, and the total filter conditions of all
groups must be 1024 or less.
Input Format
To create the filter group information:
To modify the filter group information:
1-124 GR2K-GA-0014
Ver. 07-02