Hitachi GR2000 Series Configuration Commands page 157

Default:
Range of value:
Description:
Default:
Range of value:
Description:
Default:
GR2K-GA-0014
Ver. 07-02
When specifying port numbers within a range:
Undefined
0–65535
Specifies the destination upper protocol port number. When
both destination and source upper protocol port numbers are
set under one condition, set so that the specified upper
protocol port numbers do not overlap. If they overlap, set an
upper protocol port number's pair switch as -port_pair_off.
(Note 1)
When specifying only one port number:
When specifying port numbers within a range:
Undefined
0–65535
Specifies the synchronization check method for the IP address
and the upper protocol port number as follows:
IP address with destination IP address and source upper
protocol port number with destination upper protocol port
number. However, when
this option performs checking according to that parameter
setting.
: Checks for not switching source IP
address and switching source IP address with destination IP
address and source upper protocol port number with
destination upper protocol port number (see Note later in this
subsection). When you specify this option, set the IP address
pair switch and the upper protocol port number pair switch to
off (
-ip_pair_off, -port_pair_off
When specifies this parameter, define 6 (TCP) or 17 (UDP) to
-protocol parameter. If -protocol is undefined or defined other
than 6 (TCP) or 17 (UDP), this parameter becomes invalid.
Off
Filtering/QoS Information
: Only checks for not switching source
or
-ip_pair -port_pair
).
is specified,
1-115