Case Of Using The Network Interface Board Ne100-48T - Hitachi GR4000 Series Quick Start Manual

3.3.3 Settings of Configuration Information
This section explains about the procedures for entering the edit mode to set configuration information.
(1) Enter the edit mode to set configuration information.
Enter the edit mode to set configuration definition according to the following procedures.
BSDI BSD/OS 3.1
newuser
login:
Password: ********
All Rights Reserved,Copyright(C)2003,Hitachi,Ltd.
*** Welcome to this system ***
> enable
********
Password:
# configure
(config)#
NOTE After entering the edit mode of configuration definition, a configuration information file will be
opened automatically. Note that the example above is for the case where an active configuration
information file on memory is opened. You can open a designated spare file for configuration
information by inputting a file name after the "configure file" command.
For details about a spare configuration information file, see the GR4000 Software Manual
Configuration Settings CLI-CLI Type 1 Hierarchical Input Format-.
(2) Input configuration information.
Input the following configuration information.
・Device name
・Mame for SNMP Manager
・Line name and IP address
・RIP

Case of using the network interface board NE100-48T;

Set the interface mode before inputting a line name and IP address.
For details, see the section "6.2 Case of Using the Network Interface Board NE100-48T".
QSGGR4K00-10 5794047-1X
GR4000 Quick Start Guide, Revision 1 - Preliminary
...Input a user ID.
...Input a login password.
...Register yourself as an administrator of GR4000.
...Input a password of administrator.
...Enter the edit mode.
31