Tray Size Setting [11] - Konica Minolta 7075 Instruction Manual

Tray Size Setting [11]

Select to be detected or not to be detected, and priority of detection for each tray when
ATS/APS functions.
Key Operator Mode Screen 1
Procedure
1 Press [ HELP ] to display the Help Screen, then touch Key Operator Mode .
Enter a 4-digit key operator password, then touch OK to display the Key Operator
Mode Screen. (See note.)
2 To display menus [11] to [18] of the Key Operator Mode Screen, touch
arrow key.
3 Touch [11] Tray size setting to display the Tray Auto Select Setting Screen.
4 On the left half of the screen, touch to highlight each tray key, then select OFF or ON
to specify whether the selected tray is to be automatically detected or not when ATS/
APS functions.
5 Tray keys specified as ATS/APS ON will appear on the right half of the screen.
Touch to highlight the desired tray key, then change its priority by using Up (▲) and
Down (▼) arrow keys.
6 Touch OK to complete the setting and restore the Key Operator Mode Screen.
7 If other key operator settings are required, select the desired menu item, from [1] to
[18].
8 If no further changes are required, touch PREVIOUS SCREEN to restore the Basic
Screen to perform copying operations.
NOTE:
If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
Section 12 : Key Operator Mode
Key Operator Mode Screen 2
Tray Auto Select Setting Screen
Control Panel
Adjustment
Tray Size
Setting
Lower
12 12
Key Operator Key Operator
Mode Mode
12 - 37