Table of Contents
Advertisement
Section 14 : Troubleshooting
Copying Hints (continued)
COPYING DOES NOT RESUME AFTER MISHANDLED PAPER IS REMOVED
Check copier diagram on touch screen for additional indications of mishandled paper.
COPY QUALITY IS POOR
Check paper for dampness, and replace if necessary.
THE ORIGINAL PAPER IS MISHANDLED OR SKEWED IN THE DOCUMENT FEEDER
Originals should conform to the recommended size and weight.
Be sure originals are not stapled.
Align originals evenly in the RADF.
Check to make sure paper guides meet the width of mixed size originals.
COPY IMAGE IS SKEWED WHEN BYPASS IS USED
Be sure copy paper is inserted straight.
USING EKC, COPIES CANNOT BE MADE AFTER PASSWORD IS ENTERED
Check to see if the message EXCEEDS LIMIT is displayed.
Contact key operator to reset limit.
FINISHER DOES NOT OPERATE
Touch the OUTPUT MENU key.
Remove paper misfeed, if any. Properly close finisher door.
RADF INDICATOR WILL NOT LIGHT AFTER AUTO/RESET IS PRESSED
Fully close RADF.
RADF LIGHT IS FLASHING
The document feeder is ready to accept originals.
Insert originals on RADF tray, press [ AUTO RESET ], then [ START ].
ADD TONER MESSAGE IS DISPLAYED
New toner supply is needed. Follow instructions for adding toner.
CALL FOR PM IS DISPLAYED IN MESSAGE AREA
Contact your service centre for Preventive Maintenance.
APS SELECTS THE WRONG PAPER SIZE
RADF paper guides must be adjusted exactly to the size of originals.
IN MIXED ORIGINAL MODE, A MESSAGE TO LOAD A REQUIRED PAPER SIZE
DISPLAYS, EVEN THOUGH THAT SIZE IS LOADED IN ONE OF THE TRAYS
Paper sizes loaded in the trays must be consistent with the tray position size; otherwise,
Copying Hints
the tray key on the Basic Screen will blink.
14
THE BASIC SCREEN DOES NOT DISPLAY SETTINGS AS DESCRIBED IN
T rouble-
INSTRUCTION MANUAL
shooting
Check with the key operator, as Initial Settings may have been changed.
14 - 9
Advertisement
Table of Contents
