Table of Contents
Advertisement
Section 7 : Output Modes
Group Mode Using Primary (Main) Tray
Use this mode when you want to group together multiple copies of each original, and
offset the sets upon exit. Grouped sets cannot be stapled.
❒ Incompatible Basic copying conditions: 2s1 or 2s2 mode using platen glass, Proof
copy, Folding, Stapling & Folding, Staple-sort, Sort, Tandem mode
❒ Incompatible Special Originals: None
❒ Incompatible Applications: Sheet/Cover insertion, Chapter, Combination, Booklet, OHP
interleave, Image insert, Repeat
Basic Screen
Procedure
1 Close the RADF securely, then press [ AUTO RESET ].
2 Touch OUTPUT MENU on the Basic Screen to display the Finisher Mode Selection
Screen.
3 Touch GROUP , then OK to complete the setting and return to the Basic Screen.
The Group icon will appear in the output icon display.
Finisher Mode Selection Screen
4 Make copying selections, as required.
5 Enter the desired print quantity.
6 Position originals in the document feeder. When using Store mode, see p. 6-32 to p. 6-33.
7 Press [ START ].
Copies will exit face down, with each grouped set offset by 30 mm.
NOTE:
Finisher primary (main) tray of FS-108/108BM Finisher gradually goes down while printed material
is output. DO NOT allow any object to interfere with the operation of the tray on the left side of the
finisher, as any interference may cause damage to the finisher.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the
copied sets while the paper is exiting; otherwise mishandled paper will occur.
7 - 10
3
3
2
2
1
1
30mm
Advertisement
Table of Contents
