Table of Contents
Advertisement
Section 9 : Applications
Non-Image Area Erase
The Non-image area erase mode is used to copy non standard or special originals, such
as books, magazines, paste-ups, graphs, thick or thin materials, etc. from the platen
glass. The exposed glass area outside the borders of the original will not be copied.
This mode helps to preserve the condition of originals; improves copy quality, and eliminates
unnecessary toner consumption. Keep the document cover open throughout the procedure.
Set original
The Non-image area erase has two modes; namely, Rectangular erase mode and Oblique
erase mode. The copier is initially set to Rectangular erase mode. Contact your service
centre if you desire the Oblique erase mode.
Specifications for Non-Image Area Erase
❒ Use the platen glass only.
❒ Copy mode: 1s1 mode only (when using Store mode, 1s2 mode can be selected.)
❒ Original size: A3 ~ 10mm x 10mm
❒ Image cutoff width: leading end 5mm, trailing end 4mm, top and bottom 2mm.
❒ Incompatible Basic Copying Conditions: Using RADF, 2s2, 2s1, APS, AMS, Rotation
Sort, Rotation Group, Folding, Stapling & Folding, Trimming
❒ Incompatible Special Originals: Mixed Original, Z-folded Original, SDF
❒ Incompatible Applications: Sheet/Cover Insertion, Chapter, Combination, Booklet, Image
Insert, Dual Page in RADF Store mode, Reverse Image, All-image Area, Reduce &
Shift in Image Shift, Storing image in Overlay Memory
NOTES:
• This function may not operate for the dark originals.
• This function may perform incorrectly if the lighting in the work place is directly over the platen
glass. In this case, consult your service centre about an appropriate place for installation.
9 - 34
Oblique erase mode
Non-Image Area Erase
General copying
Rectangular erase mode
Advertisement
Table of Contents
