Table of Contents
Advertisement
Section 9 : Applications
Repeat Image (continued)
To select the Auto setting mode, touch AUTO . Non-image area erase will function
automatically.
To select the Repeat mode, touch 2 Repeat , 4 Repeat , or 8 Repeat , as desired.
4 Touch OK to return to the Application Selection Screen.
5 Make additional application selections, as desired.
6 Touch OK to complete the setting and return to the Basic Screen.
APS and AMS are automatically released, and 1.00 (100%) is selected as a
magnification ratio.
7 Select the desired magnification ratio and paper size.
NOTE:
When 2 Repeat, 4 Repeat, or 8 Repeat is selected, the scanning area will be a portion of the
selected paper size equally divided according to the selected mode. In this case, magnification
ratio will be fixed to 1.00 (100%).
2
Enter Print Quantity
Enter the desired print quantity, using keypad.
To change the print quantity, press [ C (CLEAR QTY.) ] and enter the correct quantity.
3
Position Originals
Vertical/Horizontal Width Setting / Auto Detection Mode:
... FACE DOWN on Platen Glass
Position original(s) FACE DOWN on the platen glass, as shown in the illustration below.
IMPORTANT: WHEN SELECTING AUTO DETECTION MODE, KEEP THE DOCUMENT
FEEDER OPEN THROUGHOUT THE PROCEDURE.
Vertical/Horizontal Width Setting mode
Repeat Mode: ... FACE UP in RADF
... FACE DOWN on Platen Glass
Position original(s) FACE UP in the document feeder or FACE DOWN on the platen
glass.
9 - 42
Horiz. width
Verti.
width
Auto Detection mode
Advertisement
Table of Contents
