11. Fax Function; 11.1 Installing/Setting Procedure Of The Fax Kit; Install Procedure; Installation Of The Ferrite Core - Konica Minolta bizhub C228DN Service Manual

Security Function Ver. 1.01 May 2016

11. FAX function

NOTE
• When the user use the machine with the facsimile function, it is necessary to
install and setting the optional FAX kit FK-513 properly by the service engineer.

11.1 Installing/setting procedure of the FAX kit

11.1.1

Install procedure

1. Turn OFF the power switch and unplug the power cord from the power outlet.
2. Remove the four caps from the upper rear cover.
3. Remove the duct cover and the louver from the upper rear cover.
4. Remove the upper rear cover. (Nine screws)
5. Remove the metal plate. (Three screws)
6. Remove the lower left rear cover. (Two screws)
7. Remove the knockout from the lower left rear cover using nippers.
8. Reinstall the lower left rear cover. (Two screws)
9. Attach the supplied two wire saddles.
10. Attach the Fax kit. (Two supplied screws)
Insert the protrusion of the Fax kit into the slot of the machine.
Attach the Fax kit while pushing it to the right side.
11. Connect the connectors of the supplied harness and USB cable to the Fax kit.
12. Route the harness and USB cable inside the two wire saddles installed in step (9).
Make sure that the blue cable tie securing the harness is positioned at the predeter-
mined position.
13. Route the harness inside the edge cover and insert the connector into the MFP board.
14. Connect the USB cable to the port.
15. To install the covers and other parts removed in steps (2) to (5), reverse the removal
procedure.
11.1.2

Installation of the ferrite core

Perform the steps only when a Fax Kit which has a ferrite core bundled for applicable mar-
keting area is installed.
If the telephone is not connected to the main unit, keep the ferrite core in a safe place.
1. Attach the supplied ferrite core to the modular cable of the telephone.
Install the ferrite core by winding the cable two turns.
Attach the ferrite core at the position same as where a ferrite core has been attached
on the supplied modular cable.
2. Connect the modular cable of the telephone to the TEL port.
Connect the jack on the end near the ferrite core to the Fax kit.
11.1.3

Connecting the modular cable

1. Connect the supplied modular cable to the LINE port.
Connect the jack on the end near the ferrite core to the Fax kit.
Only analog circuits are allowed for users connecting to the Key Telephone System or
private branch exchanges (PBX).
2. Attach the supplied clamps on the upper and lower sides of the ferrite cores and secure
them on the back side of the machine.
43
11. FAX function