Table of Contents
Advertisement
Section 13 : Maintenance & Supplies
Loading Tabbed Sheets in Tray 4 (LT-401/LT-411)
Load offset tabbed sheets so that the tab extensions are on the right at the rear (not front)
of the tray. The tab extension width should be 12.5 mm or less.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the
Key operator mode; otherwise mishandled paper may occur. See p. 12-23 to p. 12-24.
The top sheet is designated face up as the first tab of the finished set.
Subsequent offset tab sheets follow in sequence.
Front
Front
13 - 6
Example (LT-401): 3 Tabbed sheets loaded in position for one finished set.
Rear
Section 1
Introduction
Printed
side
Example (LT-401): 9 Tabbed sheets loaded in position for 3 finished sets.
Rear
Section 1
Section 1
Introduction
Section 1
Introduction
Printed
Introduction
side
1st TAB
Section 1
Introduction
2nd TAB
3rd TAB
ONE FINISHED SET
1st TAB
2nd TAB
1st TABS
2nd TABS
Section 1
Section 1
Introduction
Introduction
3rd TABS
3rd TAB
3 FINISHED SETS
1st TAB
2nd TAB
3rd TAB
Section 1
Introduction
Advertisement
Table of Contents
