Table of Contents
Advertisement
Section 12 : Key Operator Mode
Memory Switch Setting [13] (continued)
No. 41: Trimmer (STD/ Non STD size)
No. 42: Timer which prohibits Printer
No. 43: Bookmark function
No. 44: Side 2 print (STD repeat + zoom)
No. 45: Delete of overlay image
Key Operator Mode Screen 1
Procedure
1 Press [ HELP ] to display the Help Screen, then touch Key Operator Mode .
Enter a 4-digit key operator password, then touch OK to display the Key Operator
Mode Screen. (See note.)
2 To display menus [11] to [18] of the Key Operator Mode Screen, touch
arrow key.
3 Touch [13] Memory switch setting to display the Memory Switch Setting Screen.
4 Use the procedure below to select the desired item and change the setting.
(1) Touch the arrow keys (▲) and (▼) at the right on the Memory Switch Setting
Screen to select the desired item.
(2) Touch the arrow keys
(3) Touch Change Setting Contents to change the setting of the highlighted item.
(4) Repeat above steps (1) to (3) to make several changes in succession.
5 Touch PREVIOUS SCREEN to restore the Key Operator Mode Screen. If other key
operator settings are required, select the desired menu item, from [1] to [18].
6 If no further changes are required, touch PREVIOUS SCREEN to restore the Basic
Screen to perform copying operations.
NOTE:
If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
12 - 40
STD size/ Non STD size
OFF/ 15 seconds/ 30 seconds/ 60 seconds/ 90
seconds
ON (It is cancel every JOB)/ ON (It is not cancel
every JOB)/ OFF
Rotation (180 angle) by force/ Normal
Permission (Delete/Overwrite)/ Prohibition (Delete/
Overwrite)
Key Operator Mode Screen 2
Memory Switch Setting Screen
and
at the lower left to scroll the screen.
Lower
Advertisement
Table of Contents
