Table of Contents
Advertisement
Section 9 : Applications
Image Shift (continued)
Procedure
1
Set Copying Conditions
1 Close the RADF securely, then press [ AUTO RESET ].
2 Select 1s1, 1s2, 2s2 or 2s1 copy mode from the Basic Screen, as required.
3 Touch APPLICATION on the Basic Screen to display the Application Selection Screen.
4 Touch Image Shift to display the Image Shift Selection Screen.
Application Selection Screen (when selecting Image Shift mode)
Image Shift Selection Screen
5 Touch Image Shift or Reduce & Shift .
6 To set shift amount in Image Shift:
(1) Touch FRONT , BACK , or BOTH SIDES . When BOTH SIDES is selected, the
entered shift direction and amount will be reflected immediately in the FRONT
and BACK images on the screen. Touch FRONT or BACK to specify the shift
direction and amount individually.
NOTE:
When selecting 1s1 or 2s1 copy mode in step 2, setting for back side is not needed and will
be ignored, if specified.
(2) Touch UP SHIFT , DOWN SHIFT , RIGHT SHIFT , or LEFT SHIFT to specify the shift
direction, then use the touch screen keypad or up/down arrow key to select the
desired shift amount (available range: 0~250mm). Keep touching the arrow key
to increase or decrease the value continuously.
The image display on the screen allows you to view the binding margin to be
created on the printed sheets. The following icons will appear to show the currently
selected conditions.
UP
DOWN
9 - 52
RIGHT
LEFT
UP&RIGHT
UP&LEFT DOWN&RIGHT DOWN&LEFT
Advertisement
Table of Contents
