Table of Contents
Advertisement
Section 9 : Applications
Repeat Image (continued)
Specifications for Repeat Image
❒ Vertical/Horizontal Width Setting Mode Specifications
Use the platen glass. (Document feeder cannot be used.)
Repeat width: 10 ~ 150mm (in 1mm increments)
Copy mode: 1s1 mode only (When selecting 1s2 mode, Platen store mode will function
automatically.)
❒ Auto Detection Mode Specifications
Use the platen glass. Non-image Area Erase will function automatically.
Scanning area: A3 ~ 10mm x 10mm
Repeat image area: Original image area detected by Non-image Area Erase
Copy mode: 1s1 mode only (When selecting 1s2 mode, Platen store mode will function
automatically.)
❒ Repeat Mode Specifications
Magnification ratio: Set to 1.00 (100 %) automatically. Magnification can be changed,
however, Rotation will not function when changed.
Scanning area: A3 ~ 10mm x 10mm
Repeat image area: A portion of the selected copy size equally divided according to the
mode (2, 4, or 8 Repeat) designated on the screen. If detected image size is larger than
the size figured out as above, the copy result may not be satisfactory.
❒ Incompatible Conditions with Vertical /Horizontal Width Setting Mode
Basic copying conditions: Using RADF, 2-2, 2-1, APS, AMS, Group, Rotation Sort,
Rotation Group
Special Originals: Resolution (Very high), Mixed Original, Z-folded Original, SDF
Applications: Sheet/Cover Insertion, Chapter, Combination, Booklet, OHP Interleave,
Image Insert, Dual Page, Non-image Area Erase, Reverse Image, Frame/Fold Erasure,
AUTO Layout, Image Shift, Stamp/Overlay, Storing image in Overlay Memory
❒ Incompatible Conditions with Auto Detection Mode
Basic copying conditions: Using RADF, 2-2, 2-1, APS, AMS, Group, Rotation Sort,
Rotation Group
Special Originals: Resolution (Very high), Mixed Original, Z-folded Original, SDF
Applications: Sheet/Cover Insertion, Chapter, Combination, Booklet, OHP Interleave,
Image Insert, Dual Page, Reverse Image, Frame/Fold Erasure, AUTO Layout, All-image
Area, Image Shift, Stamp/Overlay, Storing image in Overlay Memory
❒ Incompatible Conditions with Repeat Mode
Basic copying conditions: Rotation (when magnification is changed from 1.00.), APS,
AMS, Group, Rotation Sort, Rotation Group
Special Originals: Resolution (Very high), Mixed Original, Z-folded Original
Applications: Sheet/Cover Insertion, Chapter, Combination, Booklet, OHP Interleave,
Image Insert, Dual Page, Non-image Area Erase, Reverse Image, Frame/Fold Erasure,
AUTO Layout, Image Shift with 4/8 Repeat, Overlay, Storing image in Overlay Memory
NOTE:
The Auto Detection and Repeat mode of the Repeat image function may not operate properly if
the lighting in the work place is directly over the platen glass. In this case, consult your service
centre about an appropriate place for installation.
9 - 40
Advertisement
Table of Contents
