Table of Contents
Advertisement
Staple-Sort Mode Using Primary (Main) Tray (continued)
5 Touch OK on the Finisher Mode Selection Screen to complete the setting and return
to the Basic Screen.
The selection made in stapling position will be reflected in the output icon display.
6 Select additional copying features, as required.
7 Enter desired print quantity.
NOTES:
• See the table on p. 7-6 to be sure that the finisher capacity is not exceeded.
• Service can set the copier to stop copying when the copies exceed the finisher capacity. Contact
your service centre, if desired.
8 Position originals in the document feeder. When using Store mode, see p. 6-32 to p.
6-33.
9 Press [ START ].
Copies will exit face down, with the page heading toward the front of the copier.
NOTE:
Finisher primary (main) tray of FS-108/108BM Finisher gradually goes down while printed material
is output. DO NOT allow any object to interfere with the operation of the tray on the left side of the
finisher, as any interference may cause damage to the finisher.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the
copied sets while the paper is exiting; otherwise mishandled paper will occur.
Section 7 : Output Modes
7 - 9
7
Output
Modes
Staple-Sort
Advertisement
Table of Contents
