Table of Contents
Advertisement
Section 7 : Output Modes
Manual Stapling (continued)
Procedure
1 Place a set of paper to be stapled into the cover sheet
feeder, then align the guide plate. The indicator light of
Staple Start/Stop button will turn green.
NOTE:
Refer to the specifications on previous page for available paper
size in each mode.
2 Press Staple Mode Selection button to select the desired staple mode.
3 Press Staple Start/Stop button.
Stapled sheets will be delivered to the appropriate tray according to the selected
staple mode.
NOTE:
CLOSE THE TRIMMER STACKER COVER; otherwise the machine cannot print/copy.
DO NOT OPEN THE TRIMMER STACKER COVER DURING PRINTING/COPYING; otherwise,
the machine will cease operating and a paper misfeed will occur.
NOTE:
If you want to stop the manual stapling operation, press the Staple Start/Stop button again. The
finisher will cease operating. When using Stapling & Folding mode, the unfinished set will be left
in the stacker unit inside the finisher.
CAUTION
When the Booklet tray / Trimmer unit tray capacity is exceeded, the finisher will cease
operating. To avoid such trouble, select an appropriate print quantity from the specifications
on p. 7-12.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the
copied sets as they exit; otherwise, mishandled paper will occur.
7 - 24
MANUAL OPERATION
MANUAL OPERATION
Advertisement
Table of Contents
