11. Fax Function; 11.1 Installing/Setting Procedure Of The Fax Kit; Install Procedure; Routing Of The Modular Cable - Konica Minolta bizhub C236DN Service Manual

Security Function Ver. 1.01 May 2016

11. FAX function

NOTE
• When the user use the machine with the facsimile function, it is necessary to
install and setting the optional FAX kit FK-514 properly by the service engineer.

11.1 Installing/setting procedure of the FAX kit

11.1.1

Install procedure

1. Turn OFF the power switch and unplug the power cord from the power outlet.
2. Open the rear right cover.
3. Remove the connector cover at the lower portion inside the cover. (One screw)
4. Remove the shield cover (FAX1) from the lower under side, inside the door. (Two
screws)
When installing a second fax kit, remove the shield cover (FAX2) from the upper side.
5. Make sure that the fax kit switch keys are placed in "Line 1."
When installing a second fax kit, flip the fax kit switch keys into "Line 2."
6. Insert the fax kit into the under socket (FAX1) and secure it with the two screws
removed in step (4).
Be careful not to pinch the harness between plates.
When installing a second fax kit, insert the FAX kit into the upper socket (FAX2).
When installing a second fax kit, insert the supplied modular cover into the modular
jack (TEL) for "Line-2."
7. Connect each of the two connectors of the fax kit to the corresponding port of FAX1.
When installing a second fax kit, connect the two connectors to respective ports of
FAX2.
8. Route the fax kit harness and the USB cable.
9. Reinstall the connector cover that has been removed in step (3).(One screw)
Fit the connector cover protrusion in the portion of the machine.
Be careful not to pinch the harness.
11.1.2

Routing of the modular cable

A. When the ferrite core is not installed to the supplied modular cable
1. Insert the supplied modular cable in the modular jack (LINE).
If the user is connected with a key telephone system or a private branch exchange
(PBX), do not connect the modular cable to where other than an analog line.
2. <Only when using the telephone line>
Insert the modular cable of the telephone line to the modular jack (TEL) of the fax kit
(Line 1).
3. <Only when installing line 2>
Insert the supplied modular cable in the modular jack (LINE).
If the user is connected with a key telephone system or a private branch exchange
(PBX), do not connect the modular cable to where other than an analog line.
4. Place the modular cable in the harness guide.
5. <When adding no paper feed options/desk or when using the Desk DK-705>
Pass the modular cable into the hole in the lower portion of the rear right cover.
<When using the Paper Feed Cabinet PC-410/PC- 210/PC-110 or desk DK-510>
a) Remove the rear right cover from the paper feed cabinet or the desk. (Two screws)
b) Remove the knockout from the rear right cover using nippers.
c) Route the modular cable through the three wire saddles.
d) Route the cable through the notch and attach the rear right cover. (Two screws)
43
11. FAX function