Table of Contents
Advertisement
Section 5 : Copier Management
Weekly Timer Function
When a copier is under control of the weekly timer function,
the TIMER indicator on the right side of the control panel is lit.
Important: When the TIMER indicator is lit, the copier will
automatically be turned off. Do not turn it off by pressing power
switch.
Timer Interrupt
When the TIMER indicator light is on and other indicators are off, copying is unavailable
due to the weekly timer function.
However, copying is available by following procedure.
Procedure
1 Press the [ POWER SAVER ON/OFF ].
The Basic screen will be displayed along with the
messages shown below.
Timer interrupt mode
Enter password
NOTE:
The timer interrupt password is not factory set and must be entered
by the key operator (see p. 12-35 in "Section 12: Key Operator
Mode"). In the event the timer interrupt password has not been
entered by the key operator, the message shown in step 3 will
display instead.
2 Enter a 4-digit number timer interrupt password using
the keypad on the control panel.
If an invalid password is entered, continue by entering
the valid 4-digit password.
Timer interrupt mode
Enter password ✻✻✻✻
3 Press [ START ].
Input copy time
0 hour(s)
5 - 6
05 minute(s)
TIMER
INTERRUPT
POWER SAVER
ON / OFF
PROOF COPY
STOP
TY.
START
TIMER
INTERRUPT
POWER SAVER
ON / OFF
PROOF COPY
STOP
TY.
START
R
INTERRUPT
PROOF COPY
COUNTER
CLEAR QTY.
START
Advertisement
Table of Contents
