Avaya Communication Manager Administrator's Manual page 1620

Screen Reference
This delay serves two purposes:
It ensures that the answer supervision signal is valid and not a secondary delay-dial or
●
wink-start signal.
It ignores momentary off-hook signals resulting from connections made off-network
●
through certain No. 5 Crossbar CCSA switches as the connection is being established.
Therefore, calls aren't dropped inappropriately.
Code
This display-only field shows the type of circuit pack physically installed or logically
administered at the location to which this member is assigned. If no circuit pack is installed or
administered at the port address you enter, the field is blank.
Mode
This field specifies the signaling mode used on tie trunks with TN722A or later, TN760B or later,
TN767, TN464 (any suffix), TN437, TN439, TN458, or TN2140 circuit packs. This entry must
correspond to associated dip-switch settings on the circuit pack.
!
CAUTION:
Customers should not attempt to administer this field. Please contact your Avaya
CAUTION:
technical support representative for assistance.
Valid entries
e&m
simplex
protected
1620 Administrator Guide for Avaya Communication Manager
Usage
Enter e&m for 6-wire connections that pair 2 signaling wires
with 4 voice wires. You'll use e&m in the vast majority of
systems in the U.S.
Enter simplex for 4-wire connections that do not use an
additional signaling pair. This configuration is very rare in
the U.S.