Show Eapol - Enterasys SECURESTACK C3 Configuration Manual

This example shows how to reset the 802.1X quiet period to 60 seconds on ports ge.1.1‐3:
C3(su)->clear dot1x auth-config quietperiod ge.1.1-3

show eapol

Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display EAPOL status for ports
C3(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table 26‐2 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to "set eapol" on
page 26‐23.
(Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐1.
Authentication State
--------------------
Initialize
Initialize
Initialize
.1.1‐3:
ge
Authentication Mode
--------------------
Auto
Auto
Auto
SecureStack C3 Configuration Guide 26-21
show eapol