To Remove A Primary Hard Disk From A Raid Hard Disk Cage; Removing A Mirror Hard Disk From A Raid Hard Disk Cage - Nortel BCM200 Installation And Maintenance Manual

To remove a primary hard disk from a RAID hard disk cage

1 Remove the RAID hard disk cage from the main unit (see
page 260).
2 Disconnect the hard disk IDE connector from the primary hard disk.
3 Unscrew the hard disk retainer screws from both sides of the RAID hard disk cage (see
129). Place the retainer screws in a safe location.
4 Remove the primary hard disk from the RAID hard disk cage (see
Figure 129 Remove the primary hard disk from the RAID hard disk cage
Disconnect the primary hard disk IDE ribbon cable from
1
the primary hard disk IDE connector
Mirror hard disk ribbon cable
5
Place the primary hard disk on a flat, clean, and static-free surface.

Removing a mirror hard disk from a RAID hard disk cage

Use this procedure to remove the mirror hard disk from the RAID hard disk cage for the BCM200
and BCM400 system. Use this procedure if you need to replace a faulty mirror hard disk.
Nortel recommends that you replace the failed mirror hard disk to retain full redundancy. Replace
the failed mirror hard disk during a period of low call traffic. If you choose to remove both the
primary and mirror hard disks from the hard disk cage, place an identifying mark on the primary
hard disk to ensure correct installation.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
Chapter 22 Replacing the hard disk
BCM400 RAID shown
BCM200/400 4.0 Installation and Maintenance Guide
"Removing a hard disk cage" on
Figure 129).
Remove the primary hard disk
2
retainer screws
Primary hard disk ribbon cable
Remove the primary hard disk from
3
the hard disk cage
269
Figure