To Configure Dhcp Server Settings - Nortel BCM200 Installation And Maintenance Manual

3 Configure the Date and Time attributes (see
Table 70 Date and Time attributes
Attribute
Date and Time source
NTP server
Date and time
Time zone

To configure DHCP server settings

1
From the Configuration tab, click the Data Services folder to expand it.
2
Select DHCP Server.
3 Select the DHCP Settings tab.
4 Configure the DHCP mode attribute. Select either DHCP Server or DHCP Relay Agent from
the dropdown list.
5 Click the Subnets tab and select the LAN1 heading.
The details panel for LAN1 appears.
6
Select the General Settings tab.
7 Configure the attributes according to the following table.
Table 71 Subnets: General Settings attributes (Sheet 1 of 2)
Attribute
IP domain name
Primary DNS IP address
Secondary DNS IP address Allows you to specify the IP addresses of the secondary DNS server in a valid
WINS server address
Chapter 16 Using Element Manager to set the basic parameters
Table
Description
Set to NTP if the system uses a network server to determine the correct
time and date.
Set to Trunk if you want to receive time and date settings from PSTN (if
available).
Set to Manual if you want to be able to manually configure the time and
date for your system.
If Date and Time source is set to NTP, then enter an address for the
server.
Use the drop-down calendar to select the correct date and time.
Select the time zone for this system.
Description
The domain name of the network.
Allows you to specify the IP addresses of the primary DNS server in a valid dot
format.
BCM automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
dot format.
BCM automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
Allows you to specify the IP address of the WINS server.
BCM automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
BCM200/400 4.0 Installation and Maintenance Guide
70).
201