To Configure Snmp Community Strings; To Configure The Snmp Manager List - Nortel BCM200 Installation And Maintenance Manual

204 Chapter 16 Using Element Manager to set the basic parameters
5 Configure the attributes for Modify SNMP Settings (see
Table 74 Modify SNMP Settings attributes
Attribute
Enable SNMP Agent
Minimum required security
SNMP Version Support
6 Click Ok.

To configure SNMP community strings

1
From the Configuration tab, click the Administrator Access folder to expand it.
2 Select SNMP from the Administrator Access folder.
3 Select the Community Strings tab.
4
Click Add.... The Add Community String dialog box opens.
5
Configure the Add Community String attributes (see
Table 75 Add Community String attributes
Attribute
Community string
Type of access
6 Click Ok.
7
Repeat steps 4 to 6 to add more community strings.

To configure the SNMP manager list

Use the SNMP manager list to specify IP addresses that are allowed to connect to the SNMP agent.
1 From the Configuration tab, click the Administrator Access folder to expand it.
2
Select SNMP from the Administrator Access folder.
3
Select the General tab. It is normally selected by default.
4 Click Add... in the SNMP Manager List area. The Add Manager dialog box opens.
5 Enter the IP address in the Manager IP Address field.
6
Click Ok.
7 Repeat steps 4 to 6 to add another manager IP address.
N0060612 N0060612
Description
Select whether to enable or disable the SNMP agent by selecting (or not
selecting) the check box.
Select the minimum required security for SNMP from the drop-down list.
Select the SMNP version support from the drop-down list.
Description
Enter the entry name used as a key to uniquely identify an individual
community entry on the SNMP agent.
Specify the read and write access for this community. Available options are
Read Only and Read/Write.
Table 74).
Table 75).