Startup Profile Times And Led Sequence - Nortel BCM200 Installation And Maintenance Manual

Note: Make sure the bootup sequence is complete before removing the USB
storage device from the BCM system.
The Startup Profile is now loaded on your BCM system.

Startup Profile times and LED sequence

Table 77 provides details about the BCM system boot times and LED sequence using the Startup
Profile to configure system parameters.
Table 77 Startup Profile times and LED sequence
Cummulative
Duration time
(minutes) (minutes)
2 2
4 6
2 8
30 38
2 40
4 44
2 46
Note 1: If you use Element Manager to configure the parameters, the overall times are similar. Startup Profile
enables you to configure multiple parameters at once, rather than individually using Element Manager.
Note 2: To re-apply the Startup Profile, remove the applied keycode file by returning the system to factory defaults
using the BIT tool.
Next step
After you have loaded the Startup Profile, you can complete the installation process. Refer to
"Completing the initial installation (optional)" on page 213
Chapter 17 Using the Startup Profile to configure parameters
Power LED Status LED
Solid green Flashing green
Solid red off
Solid green Solid green
Solid red Solid green
Solid green Flashing green
Off (error)
Solid red off
Solid green Solid green
Comments
Initial boot sequence complete
Startup Profile functioning. Duration
varies depending on selected
parameters.
Startup Profile is successfully applied.
If there is an error the remaining steps
are not completed.
Duration varies based on selected
parameters.
Reboot complete and system is
functional.
Note: You can safely remove USB
device.
for more information.
BCM200/400 4.0 Installation and Maintenance Guide
211