Using The Backup And Restore Utility - Nortel BCM200 Installation And Maintenance Manual

250 Chapter 20 Preparing hardware for maintenance or upgrades
Figure 118 Install the BCM400 top cover
Slide cover
1
into place
3

Using the backup and restore utility

The backup and restore utility (BRU) provides a means to preserve the integrity of your BCM
system operating system software and configuration data.
Use the BRU if you need to replace the following hardware:
• Hard disk (see
• Media Services Card (MSC) (see
301)
Before you perform any substantial maintenance on the BCM system, save your data to a safe
storage module location elsewhere in the network. After hardware maintenance is complete,
restore the data to your BCM system. Access the BRU through the Element Manager main page.
For further instructions about how to operate the BRU, refer to the BCM 4.0 Administration Guide.
N0060612 N0060612
Install the top
cover screws
"Replacing the hard disk" on page
"Replacing data cards and processing hardware" on page
2
Press cover
down
255)