To Remove A Hard Disk Cage From A Bcm200 Main Unit - Nortel BCM200 Installation And Maintenance Manual

To remove a hard disk cage from a BCM200 main unit

1 Shut down the system (see
2 Disconnect the BCM system from the AC power source.
3
Attach one end of the grounding strap to your wrist and the other end to a grounded metal
surface on the BCM main unit.
4
Access the hard disk from a panel at the rear of the BCM200 main unit. Remove the hard disk
access panel screws (see
location.
5
If accessible, remove the BCM200 main unit top cover (see
cover" on page
6
Place your fingers under the tab located at the bottom rear of the hard disk cage. Lift firmly on
the tab. At the same time, slide the hard disk cage in the direction shown in
the unit detaches from the mounting points on the chassis.
7
Slide the hard disk cage through the access panel and out of the main unit. Do not place strain
the hard disk IDE or power cables.
8
Disconnect the hard disk from the system:
a
Disconnect the power supply connector from the hard disk.
b Disconnect the IDE connector from the hard disk (or RAID card).
Figure 124 Detach the hard disk cage from the BCM200 main unit
Remove access panel
1
9 Remove the hard disk cage completely from the BCM200 main unit. Place the hard disk cage
on a flat, clean and static-free surface.
"Performing a system shutdown" on page
Figure 124 on page
246).
Chapter 22 Replacing the hard disk
261). Place the panel and screws in a safe
"Removing the main unit top
2 Lift hard disk cage tab
BCM200/400 4.0 Installation and Maintenance Guide
233).
Figure 124 until
Slide the hard disk cage
toward the rear of the
3
chassis
261