Installing The Main Unit On A Flat Surface - Nortel BCM200 Installation And Maintenance Manual

98 Chapter 6 Installing the BCM main unit
Figure 58 Attach the wall-mount brackets to the BCM200 main unit
Figure 59 Attach the wall-mount brackets to the BCM400 main unit
8 Hang the BCM main unit on the backboard screws. Make sure the main unit is level. Ensure
the wood screw heads seat fully into the wall-mount bracket slots.
9 Tighten the wood screws against the wall-mount bracket.

Installing the main unit on a flat surface

Use this procedure to install the BCM main unit on any flat surface that can safely support the
weight of the unit.
Caution: Refer to
environmental conditions before selecting a location for the BCM main unit.
N0060612 N0060612
"Environmental requirements" on page 87
Install wall-mount
bracket screws
Install wall-mount
bracket screws
for acceptable