Removing The Psu Status Connector Jumper - Nortel BCM200 Installation And Maintenance Manual

• "Removing a BCM400 redundant power supply cage" on page 295
• "Installing a power supply module" on page 297
• "Removing a power supply module" on page 299
Figure 148 provides an overview of the steps required to upgrade your BCM400 system from a
standard power supply to a redundant power supply.
Note: A BCM expansion unit with a standard power supply cannot be upgraded. You
must replace the expansion unit.
Note: When you install a redundant power supply, you must also install a redundant
cooling fan included with the redundancy upgrade kit.
Note: When you install a redundant power supply, you must also remove the jumper
installed in the power supply unit status connector (RPS output signaling connector) on
the I/O card.
Figure 148 Redundant power supply upgrade overview
Shut down the
system
Set up unit for
maintenance
Note cable
routing. Remove
cables
Remove the
standard power
supply

Removing the PSU status connector jumper

Use this procedure if you are installing a redundant power supply for the first time. Use this
procedure only with the BCM400 main unit.
Note: When you upgrade to a redundant power supply, you must also install a redundant
fan. Refer to
Chapter 23 Replacing or upgrading a power supply
Install redundant
power supply
cage
Remove PSU
jumper
Make internal
connections
"Installing a BCM400 cooling fan" on page
Insert both
modules into
power supply
cage
Restore unit to
operation
Check Power LED
328.
BCM200/400 4.0 Installation and Maintenance Guide
289