Nortel BCM200 Installation And Maintenance Manual page 244

244 Chapter 20 Preparing hardware for maintenance or upgrades
7 Grasp the advanced function tray latches and partially remove the unit from the main unit. Do
not exert force on the hard disk power cables and connectors.
8
Disconnect hard disk power cable connectors.
9 Disconnect the IDE connector.
10 Remove the advanced function tray completely from the main unit.
11 Place the advanced function tray on a flat, clean, and static-free surface. If you need to remove
the hard disk component, refer to
function tray" on page
Figure 113 Remove the advanced function tray
1
Unfasten advanced function
tray latch screws
Slide advanced function tray partially away
from the main unit
N0060612 N0060612
"Removing a hard disk cage from a BCM400 advanced
262.
3
Disconnect IDE cable from I/O
5
card
Disconnect power cables from the
4
hard disk or RAID card
Move advanced function tray latches to
2
the unlocked position