To View The System Leds With Element Manager; To Resolve An Alarm Condition; Resolving Alarm Conditions - Nortel BCM200 Installation And Maintenance Manual

Figure 101 LED locations on the face of the base function tray
Trouble
indication
Component
Note: The system Status LEDs correspond to the devices, not to the PCI slots.
Note: LEDs 3 - 8 (inclusive) do not blink if there is a failure in the monitoring software.

To view the system LEDs with Element Manager

1 Open Element Manager.
2 From the Administration tab, click System Status, and then click LED Status.
The LED Status screen appears (see
3
Use this screen to view the status of the system LEDs.

Resolving alarm conditions

If the Power LED on the base function tray is red, then the system has generated a critical or major
alarm. You can view the system LED status using Element Manager, see
LEDs with Element Manager" on page

To resolve an alarm condition

1 Open Element Manager.
2 From the Administration tab, click General, and then click Alarms.
The Alarms screen appears. This screen lists all the alarms generated by the system.
3 From the Alarms screen, select the alarm you want to resolve.
Red Off
Power Disk Status
MSC
Chapter 19 System monitoring and troubleshooting
Green Flash or Off
WAN LAN 1
Modem LAN 2
Figure 102).
219.
BCM200/400 4.0 Installation and Maintenance Guide
Red
Temp Fan Reset
BCM400
"To view the system
219