Nortel BCM200 Installation And Maintenance Manual page 66

66 Chapter 2 Introducing the BCM hardware
Figure 40 BCM400 redundant power supply and modules
Power supply module
removed from the redundant
power supply unit
Figure 41 BCM400 redundant power supply connectors
Connector Configuration for
Redundant Sparkle Power Supply
In addition, international (non-North American) users require a power supply adapter cord for
each main unit and expansion unit.
N0060612 N0060612
Cable Lengths and
Markings
Route to Media bay backplane 1: Tie any slack at
the connector (behind the MBM).
550mm (P2)
Route to Media bay backplane 2: Tie any slack at
the connector (behind the MBM).
550mm (P3)
325mm to first
To hard disk: Tie any slack at the power supply.
(P4), +50mm to
Tuck any loose connectors under the hard disk
next (P5),
+100mm to last
(P6) (total 475mm)
340mm to first Unused. Tie to the center of the hard disk cage.
(P7)(right angle) ,
+150mm to next
(P8) (total 490mm)
Route to the I/O card.
515mm (P1)
Route to the I/O card.
515mm (P9)
Route to the I/O card.
515mm (PA)
Unused
300mm (PB)
Power supply module
inserted in the
redundant power
supply unit
Purpose and Notes