To Determine Mbm Dip Switch Settings; Determining Mbm Dip Switch Settings - Nortel BCM200 Installation And Maintenance Manual

116 Chapter 8 Installing a media bay module (MBM)

Determining MBM DIP switch settings

Assign DIP switch settings before you install an MBM. The DIP switches are located on the back
or underside of the MBM.
Note: Fiber expansion module (FEM) switches
The switches on the fiber expansion module (FEM) do not work in the same way as those
of the trunk or station MBMs. On the FEM, the switches turn the fiber ports on and off.
For information about setting the switches on an FEM, refer to
page 134.

To determine MBM DIP switch settings

1
Use Table
setting for all MBMs except the FEM.
and how to do the following steps.
2 On Table 28,
3 Number the order in which you want to assign the MBMs.
4
Determine the number of DS30s each MBM requires. For some station MBMs this depends on
whether you choose to set the MBM to single or double density.
5 Circle the DS30 bus and offset numbers.
6
Follow the DS30 bus and offset numbers to the far right column where the switch settings are
indicated. Circle the setting for each MBM.
Note: If you must assign specific line or extension numbers to an MBM, refer to the
individual switch tables in
and DN listings.
N0060612 N0060612
28, Table 29 (trunk MBMs), and
Table 29, or Table 30
"Assigning line and extension numbers" on page 122
Table 30 (station MBMs) to determine a switch
Figure 70 on page 117
circle the MBM names.
"FEM switch settings" on
shows an example of the table
for line