To Configure The Modem; To Select The Region - Nortel BCM200 Installation And Maintenance Manual

4 Press OK.
5 Press CHNGE to modify the IP settings. The display screen shows if DHCP is enabled or
disabled.
6 Do one of the following:
a If DHCP is currently enabled:
• Press DIS to disable DHCP. You have the option to modify the IP Address, Subnet Mask,
and Default Gateway. However, these settings have no effect as long as the system is
disabled.
• Press IP to modify the following IP settings:
— IP Address
— Subnet Mask
— Default Gateway
b If DHCP is currently disabled:
• Press ENL to enable DHCP. The system must reboot to enable DHCP.
• Press IP to modify the IP settings. You have the option to modify the IP Address, Subnet
Mask, and Default Gateway. However, these settings have no effect as long as the system
is disabled.
7 Press Back to reboot the system.

To configure the modem

1 Select Feature 9*8 from a two-line display telephone.
2 Enter the following user ID and password:
User ID: SETNNA
Password: CONFIG
The numerical values of the user ID and password are 738662 and 266344, respectively.
3 Press NEXT to scroll through the menu and select Modem.
4 Press OK. The display screen shows if the modem is enabled or disabled.
5
Do one of the following:
a If the modem is disabled, press ENL to enable the modem.
b If the modem is enabled, press DIS to disable the modem.
For more information on modem configuration refer to the BCM 4.0 Networking Configuration
Guide.

To select the region

You set the region using Feature **PROFILE from a two-line display telephone.
Refer to the BCM 4.0 Telset Administration Guide for information on using Telset Administration
to set this parameter.
Chapter 15 Using Telset Administration to set the basic parameters
BCM200/400 4.0 Installation and Maintenance Guide
191