To Set Mbm Dip Switches; Setting Mbm Dip Switches - Nortel BCM200 Installation And Maintenance Manual

Setting MBM DIP switches

Before you install the MBMs into the BCM system, you must set the DIP switches. Make a note of
these settings either on the chart shown in

To set MBM DIP switches

1 Locate the DIP switches on the MBM. See
Figure 71 MBM DIP switches
Back of the MBM
Note: The GASM and GATM MBMs have a different DIP switch configuration
than shown in
2
Set the switches to correspond with the settings you chose in the procedure
MBM DIP switch settings" on page
3 Repeat step 2 for each MBM you want to install.
Chapter 8 Installing a media bay module (MBM)
Table 28
Underside of the
MBM
6 5 4 3 2 1
DIP switches
Rear view of the MBM
Figure 71.
116.
or in the Programming Record form.
Figure 71.
Off
On
On
1 2 3 4 5 6
Off
BCM200/400 4.0 Installation and Maintenance Guide
121
MBM is
right-side up
"To determine