Regenerating A Keycode After System Replacement - Nortel BCM200 Installation And Maintenance Manual

184 Chapter 13 Initializing the system
To generate a keycode through the Nortel Keycode Retrieval System (KRS), you require:
• Username and password for the KRS (http://www.nortel.com/servsup/krs)
• BCM 4.0 feature authorization code for each feature
• BCM 4.0 system ID
You can apply a keycode file using:
• Element Manager (see
• Startup Profile (see
• Telset Administration (see
For more information on keycodes, refer to the Keycode Installation Guide.

Regenerating a keycode after system replacement

If you replace your media services card (MSC), you must regenerate your keycode file to reflect
the new system identification. Apply the keycode file after you perform your system data restore.
For more information, refer to the Keycode Installation Guide.
Next step
After connecting to the BCM system, proceed to
N0060612 N0060612
"To enter a keycode" on page
"Using the Startup Profile to configure parameters" on page
"To enter the keycodes" on page
197)
190)
"Configuring the BCM system" on page
207)
185.