To Load The Startup Profile Data Onto The Bcm System - Nortel BCM200 Installation And Maintenance Manual

210 Chapter 17 Using the Startup Profile to configure parameters
6 Enter the remaining information into the Startup Profile editor that you want loaded onto the
BCM main unit.
The Startup Profile editor contains explanations of the various parameters. Click the cell
where you want to enter information, and the Help text appears.
You can specify which parameters to load onto your system by selecting Apply for the
parameters you want to load. If you do not want to load certain parameters, select Ignore.
7 When you have entered all the information, click the large button at the top of the Startup
Profile template to save a version of the Startup Profile (.sps file) and a version of the Startup
Profile editor (Excel spreadsheet) on your computer.
8
Exit from Microsoft Excel.
9 Insert the USB storage device into the USB port of the computer.
10 Copy the Startup Profile (.sps file) to the root directory of the USB storage device.
11 If you want to apply your keycode file using the Startup Profile, copy the keycode file to the
root directory of the USB storage device.
The name of the keycode file on the USB storage device must exactly match the filename you
entered in the Startup Profile editor.
12 Remove the USB storage device from the USB port of the computer.
The Startup Profile is now stored on the USB storage device.

To load the Startup Profile data onto the BCM system

1
Turn off the power switch at the rear of the main unit.
2
Insert the USB storage device into the USB port on the main unit.
3 Turn on the power switch at the rear of the main unit.
The BCM system automatically detects the Startup Profile file and loads the information
during the bootup sequence. Loading the Startup Profile increases the time for the BCM
system to boot depending on the selected parameters. See
Profile times and LED status.
The Startup Profile is not fully loaded until the system reboots.
Note: The Startup Profile functions only on a BCM system that does not have a keycode
file applied. After a keycode file is applied, the Startup Profile does not function. This
condition prevents overwriting of the parameters of a configured system.
To re-apply the Startup Profile, remove the applied keycode file by returning the system to
factory defaults using the BIT tool.
3
Remove the USB storage device from the USB port on the BCM main unit. See
the appropriate point in the sequence to remove the USB storage device.
N0060612 N0060612
Table 77 for details about Startup
Table 77 for