To Connect To The Bcm System; To Enter A Keycode; Configuring The Initial Parameters - Nortel BCM200 Installation And Maintenance Manual

To connect to the BCM system

1 Open BCM Element Manager.
2 From the Network menu, select New Network Element, and then select Business
Communications Manager.
3 Enter the BCM system IP address, the username, and password (the default is are shown
below):
IP address: 10.10.10.1
Username: nnadmin
Password: PlsChgMe!
4 Click OK.
5 From the Network Elements folder, select the BCM system IP address.
6 Make sure that the correct username and password are entered.
7
Click Connect.
You are now connected to the BCM system.
For more information on using BCM Element Manager, refer to the online Help within BCM
Element Manager.

Configuring the initial parameters

Use the following procedures to configure the initial parameters for the BCM system using BCM
Element Manager:
•

"To enter a keycode"

• "To configure the LAN IP address"
• "To configure the modem" on page 198
• "To configure the startup template for telephony services" on page 199
• "To initialize voice mail" on page 199
To enter a keycode
1
From the Configuration tab, click the System folder to expand it.
2
Select Keycodes. The Keycodes panel opens.
3 Click Connect to Nortel Keycode Retrieval System. The Open dialog box opens.
4 Select the keycode file for your system and click Open.
Refer to the Keycode Installation Guide for details on how to retrieve and enter the keycodes for
your system.
Chapter 16 Using Element Manager to set the basic parameters
BCM200/400 4.0 Installation and Maintenance Guide
197