Nortel BCM200 Installation And Maintenance Manual page 149

Table 50 ASM wiring chart
Wiring for an ASM 8 or GASM8
25-pair female
amphenol
connector
WARNING: Ensure that you have Tip (T) and Ring (R)
connected to the appropriate pins.
Note: Refer to
between the DS30 channel number and the DNs. Configuration information is included in
the BCM 4.0 Administration Guide.
2
Install the telephones and peripheral equipment (if it is a new system):
a Attach the cables for the telephones to the connecting blocks.
b Install the telephones. Refer to
3
Plug the female amphenol connector into the interface on the front of the MBM.
4 Set up any mobile system you are using.
• Ensure the base stations are correctly installed and connected to the appropriate MBMs on
the BCM system. In the case of the Wireless LAN IP telephone system, ensure that the
access point is correctly set up to connect to the BCM system LAN or WAN.
• Configure and register the handsets according to the instructions provided for each type of
system.
5T
2T 7T
4T
1T 3T
6T
30R
32R
28R
26R
31R
29R
27R
"Assigning line and extension numbers" on page 122
"Installing telephones and peripherals" on page
Chapter 9 Connecting the cables
Pin Wire color
26 White-Blue
1 Blue-White
27 White-Orange
2 Orange-White
28 White-Green
8T
33R
3 Green-White
29 White-Brown
4 Brown-White
30 White-Slate
5 Slate-White
31 Red-Blue
6 Blue-Red
32 Red-Orange
7 Orange-Red
33 Red-Green
8 Green-Red
34-50 no connection
9-25
BCM200/400 4.0 Installation and Maintenance Guide
149
Port Set #
X01 1
X01 1
X02 2
X02 2
X03 3
X03 3
X04 4
X04 4
X05 5
X05 5
X06 6
X06 6
X07 7
X07 7
X08 8
X08 8
to see the relationship
163.