To Configure Snmp Settings - Nortel BCM200 Installation And Maintenance Manual

4 Configure the IP Terminal Global Settings attributes (see
Table 73 IP Terminal Global Settings attributes
Attribute
Enable registration
Enable global registration
password
Global password
Auto-assign DNs
Advertisement/Logo
Tip: To automatically configure IP Phones with DNs assigned:
After the IP Phones are operational, clear the Enable registration check
box.
You can configure other attributes on the IP Terminal Global Settings tab depending on the
requirements for your system.

To configure SNMP settings

1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select SNMP from the Administrator Access folder.
3
Select the General tab. It is normally selected by default.
4 Click Modify in the SNMP Settings area. The Modify SNMP Settings dialog box opens.
Chapter 16 Using Element Manager to set the basic parameters
Description
Select this check box to allow new IP clients to register with the system.
WARNING: Remember to clear this check box when you have finished
registering the new telephones.
If you want to require the installer to enter a password when IP telephones are
configured and registered to the system, select this box.
If this box is not selected (disabled), a valid Telset user ID and password is
required to register IP phones.
If the Enable Global Registration Password check box is selected, enter the
password the installer enters on the IP telephone to connect to the system.
If this check box is left clear, no password prompt occurs during registration.
If this check box is selected, the system assigns an available DN as an IP
terminal requests registration. It does not prompt the installer to enter a set
DN.
If this check box is clear, the installer receives a prompt to enter the assigned
DN during the programming session.
Any information in this field appears on the display of all IP telephones. For
example, your company name or slogan (24 characters in length).
1) Select the Enable registration check box.
2) Select the Enable global registration password check box.
3) Leave the Global password field blank.
4) Select the Auto-assign DNs check box.
BCM200/400 4.0 Installation and Maintenance Guide
Table 73).
203