Replacing A Hard Disk In The Hard Disk Cage; Removing A Hard Disk From A Standard Configuration Hard Disk Cage - Nortel BCM200 Installation And Maintenance Manual

9 Restore the BCM system to operation. Refer to
page 234.
10 If you installed a new programmed hard disk in a standard configuration (for RAID
configuration, skip to the next step):
a
Initialize the hard disk. Refer to
on page
b After the disk is initialized, restore your data from your backups. If you did not back up
your keycodes, reenter them (see
11 If you installed a new blank hard disk (mirror or primary) in a RAID, wait for the disk mirror
process to complete. For further information on how to monitor disk mirroring progress, refer
to "RAID disk mirroring" on page

Replacing a hard disk in the hard disk cage

Use the procedures in this section to remove or install the hard disk in the hard disk cage for the
standard and RAID upgrade BCM200 and BCM400 configurations.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
Refer to the following detailed information:
• "Removing a hard disk from a standard configuration hard disk cage" on page 267
• "Removing a primary hard disk from a RAID hard disk cage" on page 268
• "Removing a mirror hard disk from a RAID hard disk cage" on page 269
• "Installing a hard disk into a standard configuration hard disk cage" on page 270
• "Installing a primary hard disk into a RAID hard disk cage" on page 271
• "Installing a mirror hard disk into a RAID hard disk cage" on page 273

Removing a hard disk from a standard configuration hard disk cage

Use this procedure to remove the hard disk from the hard disk cage for the standard BCM200 and
BCM400 system. Use this procedure only to replace a faulty hard disk.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
275.
224.
Chapter 22 Replacing the hard disk
"Restarting the system after maintenance" on
"Initializing the hard disk in a single-disk configuration"
"Software keycode" on page
BCM200/400 4.0 Installation and Maintenance Guide
183).
267