To Select The Telephony Startup Template And Start Dn; To Initialize Voice Mail; To Create Telset User Accounts - Nortel BCM200 Installation And Maintenance Manual

192 Chapter 15 Using Telset Administration to set the basic parameters

To select the telephony startup template and start DN

You set the template and start DN using Feature **STARTUP from a two-line display telephone.
Note: You can only set these parameters for only 15 minutes after system bootup.
Refer to the BCM 4.0 Telset Administration Guide for information on using Telset Administration
to set this parameter.
Other telephony startup parameters are configured using Feature **CONFIG. Refer to the BCM
4.0 Telset Administration Guide for more information.

To initialize voice mail

You initialize your voice mail system using Feature 983 from a two-line display telephone.
Refer to the CallPilot Telephone Administation Guide for information on using Telset
Administration to initialize your voice mail system.

To create Telset user accounts

Note: You can only create Telset accounts using Telset Administration. To
create Element Manager accounts, you must use Element Manager.
1
Select Feature 9*8 from a two-line display telephone.
2 Enter the following user ID and password:
User ID: SETNNA
Password: CONFIG
The numerical values of the user ID and password are 738662 and 266344, respectively.
3 Press NEXT to scroll through the menu and select User Accounts.
4
Press OK. The Accounts screen appears.
5 Press NEXT to scroll through the list of available accounts to create.
6 Press CHNGE to change the status of the current account.
7
Press CRT to create the account.
If you see the DEL command instead of the CRT command, then the account is already
created.
8
Press BACK. The Accounts screen appears.
9 Press NEXT. The password screen appears.
10 Press CHNGE to change the password.
11 Press NEXT to scroll through the list of available accounts.
N0060612 N0060612