To Install A Hard Disk Into A Standard Configuration Hard Disk Cage; Installing A Primary Hard Disk Into A Raid Hard Disk Cage - Nortel BCM200 Installation And Maintenance Manual

Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
To install a hard disk into a standard configuration hard disk
cage
1 Position the hard disk into the bottom position of the hard disk cage.
Note: For a BCM200 system, orient the hard disk so that the power and IDE connectors
are on the bottom and opposite to the hard disk cage lift tab (see
For a BCM400 system, orient the hard disk so that the power and IDE connectors are on
the bottom and on the same side as the hard disk cage lift tab.
2 Align the hard disk and hard disk cage retaining screw holes. Fasten the hard disk cage retainer
screws into both sides of the hard disk cage (see
Figure 131 Install a single hard disk in the standard configuration hard disk cage
Insert the hard disk into the
1
hard disk cage
Front view
IDE connector
Power supply
connector

Installing a primary hard disk into a RAID hard disk cage

Use this procedure to install a primary hard disk into the RAID hard disk cage for the BCM200 or
BCM400 system. Use this procedure if you need to replace a faulty primary hard disk or install a
programmed hard disk from a standard configuration.
Chapter 22 Replacing the hard disk
Figure
BCM200
shown
Hard disk
cage lift
tab
Note: Install the BCM200
connectors are opposite to the hard disk cage lift tab
BCM200/400 4.0 Installation and Maintenance Guide
Figure 131).
131).
Rear view
Align and install the
hard disk retainer
2
screws
hard disk so that the IDE and power
271