Removing And Installing The Oil Filter - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Install overflow tube -C- (with 5 mm Allen key).
– Top up with ATF and inspect ATF level
• Gasket ring -B- of ATF inspection plug must be replaced after
the ATF level inspection ⇒ Electronic Catalogue of Original
Parts .
Tightening torques
Component
Overflow in oil pan
ATF inspection plug to oil pan
Oil pan to gearbox housing
1)
Tighten crosswise in stages.
1.5

Removing and installing the oil filter

Note
⇒ "2 Information and repair instructions for the automatic gearbox
09G", page 12 .
Removing
– Removing the oil pan
⇒ "1.4 Removing and installing oil pan", page 168
– Release screws -arrows- for oil strainer.
– Take the oil filter -A- out of the slide valve body.
Install
– Thinly coat gaskets on the intake collar of the oil filter (reverse
side) with ATF.
Note
If the gaskets on the reverse side of the oil filter for the slide valve
body are defective or no longer properly attached to the oil filter,
the oil filter must be replaced.
– Position oil filter on the slide valve body and screw in screws
-arrows- to tightening torque, and tighten
⇒ "1.2 Summary of components - oil pan, oil strainer, slide
valve body, internal wiring looms", page 165
– Installing the oil pan
– Top up with ATF and inspect ATF level
170
Rep. gr.38 - Gears, control
⇒ "4 ATF", page 147
⇒ "1.2 Summary of components - oil pan, oil strainer, slide valve
⇒ "1.2 Summary of components - oil pan, oil strainer, slide valve
⇒ "1.2 Summary of components - oil pan, oil strainer, slide valve
1)
⇒ page 169 .
⇒ "4 ATF", page 147
.
body, internal wiring looms", page 165
body, internal wiring looms", page 165
body, internal wiring looms", page 165
.
.
.
Nm