Skoda FABIA II 2007 Workshop Manual page 1148

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Unscrew short screws -A- (3 screws, M8 x 35) crosswise in
stages.
Caution
Do not remove more than 7 screws!
There are 4 long and 3 short screws.
Do not loosen the screw plugs of the mechatronics .
– Grab with the hand (without gloves) at the mass, in order to
discharge yourself electrostatically.
Caution
♦ Only then touch or remove the mechatronics for double
clutch gearbox - J743- , after you have discharged yourself
electrostatically at an earthed object beforehand, e.g. skin
contact with mass.
♦ Under no circumstances must the plug contacts in the plug
of the gearbox be touched with the hands, because the
control unit can be destroyed through static discharge as
well as the mechatronics.
– Remove mechatronics.
Caution
Place down the removed mechatronics so that no oil is able to
escape through the vent (seal ventilation opening with a suit‐
able plug).
After removing the mechatronics, leave the assembly lever -
T10407- inserted between the engaging levers of the double
clutch and gearbox housing. Removing the assembly lever can
produce negative effects on the automatic adjusting device of
the clutch.
If the double clutch gearbox mechatronics - J743- "is fixed in
place" and cannot be removed
It is possible that the mechatronics cannot be removed if the gear
actuator top left on the gearbox housing jams -arrow-.
Caution
In this case, the mechatronics should not be removed with in‐
creased force.
• The mechatronics must be repositioned at the gearbox hous‐
ing, fixed with a screw, and put into removal position by hand
⇒ "1.3 Bringing the mechatronics for double clutch gearbox
J743 to the removal position by hand", page 87
Removed double clutch gearbox mechatronics - J743- is returned
with oil.
86
Rep. gr.34 - Controls, housing
.