– Turn the clutch by hand and, while turning it, pay attention to
the small engaging lever.
•
During rotation, there should be no resistance or braking.
•
During this process, the engaging lever must remain in its po‐
sition without moving. It must not move up or down -arrows-.
•
If any of these events occur when rotating the clutch, the ad‐
justing washers are not seated correctly and the clutch must
be removed again
⇒ "2.2 Remove double clutch", page 66
– Check the fitting position of the adjusting washers -arrows-.
♦ Have a close look at the adjusting washers -arrows-.
♦ The adjusting washers must be installed correctly and must
not be damaged.
♦ It is possible that there has been an error in the calculation. In
this case, check the measurement
⇒ "1.3 Adjust clutch release mechanism", page 41
– Remove the screw plugs and position both ventilation caps
-arrows- again.
Perform the
basic setting
with the ⇒ Vehicle diagnostic tester.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
after the gearbox has been fitted
Gearbox 0AM-DSG - Edition 01.2015
.
73
2. Clutch