Skoda FABIA II 2007 Workshop Manual page 1124

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Please read off and note the value of the clutch tolerance from
the new clutch -arrow-.
Example: K2 "+ 0.4 mm" is given on the clutch.
Determining the thickness of the adjusting washer "SK2"
The thickness of adjusting washer "SK2" is now determined as
follows on the basis of the determined clutch play and clutch tol‐
erance for clutch "K2".
Height tolerance of the gear shift bearing for clutch "K2"
-/+ Clutch tolerance of clutch "K2"
= Determined thickness of adjusting washer "SK2"
Example calculation:
♦ 2.17 mm + 0.4 mm = 2.57 mm
♦ Determined thickness of adjusting washer "SK2" = 2.57 mm
– Select the correct washer from the table.
Determined thickness of the
washer
from to
0,31 0,90
0,91 1,10
1,11 1,30
1,31 1,50
1,51 1,70
1,71 1,90
1,91 2,10
2,11 2,30
2,31 2,50
2,51 2,70
2,71 3,30
Example:
♦ Determined thickness of adjusting washer "SK2" = 2.57 mm
♦ Selected thickness of the adjusting washer = 2.60 mm
– From the delivered washers, determine the required adjusting
washer and put it aside until you are ready to install it.
Caution
Risk of damage to gearbox!
♦ Mark adjusting washer SK2 and prepare it as follows for
installation.
♦ Only this adjusting washer SK2 may be used for adjust‐
ment.
– Install clutch ⇒ "2.3 Install double clutch", page 69
62
Rep. gr.30 - Clutch
Shim to be installed in millime‐
tres
0,8
1,0
1,2
1,4
1,6
1,8
2,0
2,2
2,4
2,6
2,8
.