FABIA 2000
1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
17-2
Removing and installing
oil pan
Removing and installing oil pan - for a
1.0 litre engine
Removing
The procedure for removing the oil pan on a 1.0 ltr. and
1.4 ltr. engine is identical ⇒ 17-2 page 1.
Installing
Special tools, test and measuring equipment and
auxiliary items required
♦
Torque wrench
♦
Sealant -AMV 188 520-
–
Coat the joints between the timing gear cover/cylin-
derblock with sealant -AMV 188 520- before installing
the oil pan with gasket -arrows-.
–
Lay on the gasket for the oil pan.
–
Tighten securing bolts in the specified order.
Tightening torque: 10 Nm
Note
The bracket for the front coolant pipe is also attached with
bolts -2- and -6- (M6x22). Do not interchange with the
other bolts (M6x20).
Removing and installing oil pan - for a
1.4 litre engine
Special tools, test and measuring equipment and
auxiliary items required
♦
Hand drill with plastic brush attachment
♦
Flat scraper
♦
Torque wrench
♦
Silicone sealant -D 176 404 A2- or - 047 198 049-
(THREE BOND 1215 J)
♦
Counterholder -T30008-
Removing
–
Remove noise insulation below engine.
–
Drain engine oil.
–
Unbolt front coolant pipe (below oil pan) at the 2 fix-
tures at the cylinder block.
–
Unbolt oil pan together with oil pan support.
–
Remove oil pan, if necessary release by applying
slight blows with a rubber-headed hammer. Press the
coolant pipe slightly towards the outside for this step.
Edition 09.03
S00.5305.04.20
16
19
20
15 15 11
Removing and installing oil pan
8
4
12
1
7
3
2
6
17
5
9
13
17
18
14
10
N17-0079
17-2
1
page