Skoda FABIA II 2007 Workshop Manual page 858

Remove inner ring/tapered-roller bearing on the side of the gear
pinion
– Before fitting the extractor position distance sleeve -MP
3-458/2- and pressure plate -MP3-431 (3002)- on the differ‐
ential housing.
Press on inner ring/tapered-roller bearing on the side of the gear
pinion
– Support the opposite side of the inner ring with an insertion
bushing -MP3-412 (VW 455)- .
Press the outer ring/tapered-roller bearing -A- out off the clutch
housing
B - Interior extractor 46 up to 58 mm , e.g. -Kukko 21/7-
– While doing so tighten the interior extractor behind the outer
ring/tapered-roller bearing.
Press outer ring/tapered-roller bearing into the clutch housing
– Support the clutch housing with a pipe for wheel bearing -
T30019 (3345)- directly below the bearing support.
FABIA II 2007 ➤
Gearbox 02T - Edition 12.06
2. Differential gear
131